Ask Experts Questions for FREE Help !
Ask
    winia1213's Avatar
    winia1213 Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 12, 2014, 04:11 AM
    The control panel is not working properly. Won't accapt any comands.
    I have an Ultra Wash dishwater model 665.13443K901.
    The control panel is out of control, the push buttons are not responding.
    How can I reset?
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
     
    #2

    Nov 13, 2014, 07:06 AM
    Go here first: https://www.youtube.com/watch?v=flzh...skbLTXDRQN398h
    Then you can also try these instructions:
    Heated Dry, Hi Temp Wash, Heated Dry, Hi Temp Wash, Close the door, Start, open the door, Cancel 2x , or:
    1. Press "Normal Wash" and "Heated Dry" one after each other about five times.
    2. All lights on panel will light up. Wait until all lights go out and it resets itself. It will go through a test mode.
    3. Press "Cancel" and set as you normally would and press Start.
    (Originally posted by curtisst.)
    If the above does not work, do this: (From another post here)
    "1. Unlock your Kenmore dishwasher control panel by pressing and holding the "Heated Dry" button for four seconds.
    2. Press a series of four buttons in quick succession. Press "Heated Dry,""Normal Wash," "Heated Dry" and "Normal Wash" to instruct your Kenmore dishwasher to run a short diagnostic test.
    3. Wait for two minutes while your Kenmore dishwasher runs its diagnostic test.
    4. Press the "Cancel/Drain" button once your dishwasher has completed its diagnostic test. This should reset your dishwasher control panel and stop the "Clean" light from blinking repeatedly."
    I hope that this helps. Here are a few documents that should help: https://dl.dropboxusercontent.com/u/...Dishwasher.pdf
    https://dl.dropboxusercontent.com/u/...t%20Codes.docx
    https://dl.dropboxusercontent.com/u/...ishwashers.zip
    Make sure to check any safeties such as the high-water-cutout float on the bottom of the tub and anything else suggested in the manual that could be tested with a meter if the above does not help.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

66513592K600 control panel is not working [ 2 Answers ]

There seems to be no power to my 66513592K600, I have checked the power connections, what should I do now?

2000 plymouth voyager instrument panel not working properly [ 0 Answers ]

Hi. I have a 2000 plymouth voyger. The instrument panel does not work when I turn on the car. But when I shift into reverse or any other gear, the panel turns on. While on all of the gears PRND light up for a while. What could be causing this and how can I fix it? I have already changed the input...

Samsung remote control not working properly [ 4 Answers ]

My fairly new Samsung TV has a problem with the remote. The TV will only react to the signal sent from the remote if the remote is pointed at a VERY small area on the TV. i.e. the lower right corner of the screen. Is there a fix for this?


View more questions Search