Ask Experts Questions for FREE Help !
Ask
    pohandyman's Avatar
    pohandyman Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 3, 2014, 04:08 AM
    Goodman Furnace Model GMP075-3REVB Troubleshooting
    The inducer motor runs all the time won't shut off didn't think it was a problem since the A/C worked fine during the Summer. But now the furnace won't fire off the Red Light indicates the Pressure Switch so replaced it and still have the same problem. Now what can I check to get some heat. Pulled the hose off and made sure all ports were clear and pulled the hose off while unit was calling and Red Light went solid the blinked 3 times instead of 2 times, and when I put the hose back on the in a couple of minutes later the burner lit. When it called for hear again I had the same problem and I think it's because the inducer motor won't shut off. Why is this happening?
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
     
    #2

    Nov 3, 2014, 06:05 AM
    First we need to find out why the inducer motor is always running. Try turning the power off to the furnace and see if that resets the control board.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman Model GMP075-3 flame goes out 10 seconds after ignition [ 2 Answers ]

Goodman hot air furnace Fuel Source - natural gas Model - GMP075-3 Serial# - 96-7813321 Scenario : Goodman Model GMP075-3 flame goes out 10 seconds after ignition When system starts up everything appears normal, the induced draft fan starts For about 30 seconds, the hot surface ignitor...

Burner tubes for goodman heater model # gmp075-3? [ 1 Answers ]

I am having a problem adjusting flame on 2 of the 3 burners it will not adjust to a tight cone and the excess flame keeps triping heat censers I took apart and wire brushed everything inside burners can they go bad they are 17 years old.

Goodman air handlers model #GMP075-3? [ 0 Answers ]

I have a Goodman model #GMP075-3 RevB and when I turn it on it makes a horrible loud whinning noise. My husband thinks it might be a bearing in the blower motor. It stills blows cold or hot depending on how it is set so it works but the noise is so loud and annoying we don't use it. The noise...

Goodman furnaces model GMP075-3 [ 2 Answers ]

Just replaced the blower motor and now when the heat comes on the ignitor glows and the gas flows fine, but it shuts off after a few seconds. Could this be a bad flame sensor? If so should I try to clean it or just replace it?

Gas furnace problem Goodman model# GMP075-3 revb [ 20 Answers ]

When it starts up everything appears normal, the induced draft fan starts for about 30 seconds, the glow plug gets red hot, the gas ignites, about 30 seconds later the main blower wheel spins. The hot air comes out of the registers and everything works great but only for about 5 minutes, then for...


View more questions Search