Ask Experts Questions for FREE Help !
Ask
    Bola555's Avatar
    Bola555 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 16, 2014, 03:33 PM
    Does the inductor motor need to be level
    On my inductor motor there is a V shape with rubber gaskets at each point and two on top one on bottom does the two on top need to be perfectly level to keep motor from burning out
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
    		  
    #2

    Oct 16, 2014, 03:49 PM
    I think your OK with the motor. Never seen one burn up from not being level.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

E inductor motor starts but the furnace electronic pilot wouldn't light. [ 3 Answers ]

I have a Heil NTG3100GFA4 furnace and this evening just the inducer motor would start. The pilot (electronic) don't light and start the main burners. Problem solved After searching all night, I finally found the problem. The rubber hose on to pressure switch had a break in it. I did a temp...

Inductor ic [ 0 Answers ]

How to inbuild inductor using ic technology?

Can I move cold air returns to furnace at floor level from ceiling level [ 0 Answers ]

A poorly designed heating system in a room addition has left me with problems. The contractor simply ran uninsulated plastic,such as that used on dryers, into an unheated,un-insulated crawlspace causing the 3 heat vents to receive nothing but cold air. Recently I simply shut the heat vents to the...

Replacing Ruud inductor fan [ 0 Answers ]

I just got a replacement inductor fan for my Ruud 90+ furnace and the wires are in a different place. On the old fan, one wire came out of the middle of the motor on the top and one out the bottom of the motor in the middle. On the new fan, they both come out the back. How do I tell which goes...

Raising the level of a caste iron toilet flange to the level of the floor tile. [ 1 Answers ]

I have a similar problem as the person in a previous post. I installed one of those twist and sets PVC flanges right on top of my old caste iron flange but the top of the twist and set is still 3/8 inch below the tile. I am wary about using a double wax ring. Can I install one of those flange...

View more questions Search