Ask Experts Questions for FREE Help !
Ask
    Do it all impro's Avatar
    Do it all impro Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 15, 2014, 01:45 AM
    Pluming tieing into existing sewer for a new bathroom rough-in
    installing a new bathroom from existing plumbing for rough-in
    tie into existing sewer line for a new tub and toilet
    I Would like to get some first hand information for installing a new bathroom and tie into existing plumbing and sewer
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Oct 15, 2014, 06:15 AM
    Here's how we rough our bathrooms in my area. Substitute tub for shower in drawing. More questions? I'm as close as a click. Good luck, Tom
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Basement bathroom without existing rough in [ 0 Answers ]

Hello all, I see lots of help on digging out concrete for basement bathroom, but I can't seem to find out how to actually connect to my existing ejector pump setup. If I use the traditional method or a lateral type pump system what gets connected to what? I have the vent to roof from ejector...

Existing Basement Rough-in Uncertainty [ 7 Answers ]

Hi, I have a few questions regarding a basement bathroom. The house was just built, but there are no plans indicating the drain locations in the basement for the bathroom. 1. How high up do you have to build a subfloor for a basement bathroom when you would perfer not to have to break up the...

Adding toilet to existing rough in [ 1 Answers ]

I am adding a toilet in addition to one that is roughed in so I will have two toilets in the basement when I am done. Do I tie in where the sewer comes in (adding a backflow valve)or can I tie into the existing 3" toilet rough in. Also, I have a middle foundation between the two toilets. Do I go...

Tieing in a backup sump pump to existing copper discharge pipe [ 3 Answers ]

Does anyone know if I can tie in a backup sump pump into an existing copper discharge pipe of 1.5 inches. The back up pump comes with a "y" connector made of PVC. How do I connect the PVC connector into the copper discharge pipe? Thanks.

Pluming - Bathroom [ 1 Answers ]

I would like to install a bathroom upstairs. However, I do not have easy access to any 3 inch drain pipe for my toilet. I would need to travel 25 feet or so laterally, but probably wouldn't have enough drop to complete the task. I could, however, get to a 2 in drain pipe directly below my new...

View more questions Search