Ask Experts Questions for FREE Help !
Ask
    zero13's Avatar
    zero13 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 25, 2014, 01:54 PM
    How do I tell which code I am getting when the light is flashing
    The red led flashes once short then once long, for a total count of 26 each in that same order over and over. How do I determine which code this is/
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Sep 25, 2014, 02:20 PM
    There should be a code chart on the inside of the door handler . 1 short and 1 long is the code.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have a rapid flashing light code error [ 1 Answers ]

Hello, I just bought a new control board for my carrier furnace and did the replacement but now I have an error, so my question is would you reverse line polarity first or control leads ? I am afraid of ruining the board if I do the wrong one first, but I have read a lot of questions and most of...

My carrier furnace LED light is flashing a code. How do I tell what code it is? [ 1 Answers ]

The error code is flashing and I know certain lengths, long and short indicate a code but how do I tell which one it is?

I am getting four flashing trouble code light [ 2 Answers ]

My colman moble home gas furnace is flashing four times trouble code and not ignighting

Flashing red light code ? [ 10 Answers ]

OK I have seen the same question asked and followed the instructions, BUT I can't find the meaning of my code on the inside of my access panel. I have a Trane XE80 with a White-Rodgers 50a50-473 control panel, the heat cycles on and off every 20 30min. The flashing code is (I think) 14 ...

View more questions Search