Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
The P-trap doesn't meet the tail piece by 2 inches
[ 4 Answers ]
It tuns out the bowl on the new bathroom sink I'm trying to install is not as deep as the previous one. So the new tail piece which is exactly as long as the old tail piece doesn't reach the P-trap there is a 2 inch difference. It does however all line up. Is there an extension I can get. All the...
How to get earring out of narrow bathroom sink drain
[ 15 Answers ]
I had someone look underneath, the pipe doesn't come apart, I am not handy and not wanting to pay to have someone cut the pipe. I tried the vacuum cleaner trick, didn't work, Haven't run any water. Tried gum on a stick, the gum fell off. Tried magnet on a stick, the magnet broke. Any other ideas?
What to do with holes in stainless steel sink?
[ 3 Answers ]
I have small pin-holes in my stainless steel sink! I do not know how it got there or if I can repair it. Please I need advice on what to do, or if I should just replace sink. It is only 3 years old.
Raising toilet flange 4 inches
[ 0 Answers ]
Building bathroom in basement. Drain of bathtub is 6 ft away from drain in concrete. I'm adding a 2x4 sub floor, need to raise the toilet 4inches This sub floor is hiding the drain. Thanks Sigi
Closet flange bolts - brass or stainless steel or other
[ 1 Answers ]
For a cast iron closet/toilet flange, should the Johnny bolts used to attach the toilet to the flange be made of brass or stainless steel or other? If brass, will it eventually corrode the cast iron closet/toilet flange? View more questions Search
|