 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
l130 pto wiring
I have a John Deere L130. Was almost finished cutting grass when blades stopped. The tractor runs fine. It looks like a wire came out of the plug/connector located beneath the engine compartment (where it's really difficult to get to, not under PTO switch.) How do I disconnect the plug in order to get the wire back where it needs to be?
Thanks |
||||
Check out some similar questions!
Hi I have a john a john deere 145 and 2(two) yellow wires that go to the pto switch and the other wire yellow is plugged along side of the 2 wire plug separated by a plastic spacer. When the mower switch is on the plastic between the two plugs gets hot and melts the plastic spacer shutting...
PTO Clutch will not engage. Installed properly.
I need a wiring diagram to reconnect wires on clutch. Wires were broke.
My john deere l130 will not start. The engine runs fine. I replaced the pto switch, but it still will not start. Can it be anything other than the electrical? Checked the continuity to the pto and it was fine.
The engine runs fine for as long as I want it to until I pull that knob. Then it sounds like it want s to work and just dies. The belts don's spin at all when thi is occurring. Primary wheel located beneath the engine which drives the belts doesn't seem to spimove the belts. I am considereing...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
