 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How do you line up the coil magnets with the flywheel magnets on a John Deere 102?
Need to know how to properly install a coil on a John Deere 102 garden tractor. I know to use the card provided with the new coil to get the gap right... but how do I line up the magnets in the flywheel with the coil? Or is that even necessary?
|
||||
|
||||
|
Hi,
Begin with the magets away from the coil (slightly to the left, insert carboard gauge with coil screws slightly snug, rotate flywheel until magnets are on one side oe gauge and coil is centered on other side and magnets pull the coil toward the flywheel. Tighten screws and rotate flywheel and gauge clockwise to remove gauge. Reassemble. Peace, Clarke |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I recently acquired a John Deere 102 Briggs and Stratton 17 HP OHV. Its pretty new and in great condition, but when I got it, the engine did not run. I replaced the battery and spark plug, checked the oil and air filters, and cleaned the carb. It now starts perfectly at full throttle/choke and runs...
16.5 hp kohler motor on a craftsman mower. Can the flywheel magnets go bad? If so how do you check them. We have replaced coil,elec box, switch. The gap is 0.010 on the coil. It's not on upside down. The keyway isn't sheered. My dad and I are usually pretty good on this kind of stuff and the...
I have a john Deer L100 and the fly wheel keeps sticking when I try to crank it. It has now broken the starter what do I need to do to fix the fly wheel before replacing the starter?
I have magnets to keep kitchen cabinets closed. Two of the magnets have gotten very weak. How is it possible to restore the power of the magnet? Thank you!
I have a 12.5 horsepower Briggs motor. The magnets come loose from the inside of flywheel. Is it possible to glue them back in? Will it work?
View more questions Search
|
