Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Raising a concrete floor by 6 inches
[ 2 Answers ]
I have an out building that I want to convert into a room but the floor needs to be raised by 6 inches, does anyone have any ideas to help?
Is a closet/toilet flange with a height of .375" to .50" above floor to high?
[ 4 Answers ]
I'm remodeling my bathroom. I tore up an old mud job floor leaving the closet flange /toilet flange at a height of 1.375" to 1.5". I will be adding 3/4" subfloor with 1/4" tile. This should leave me a flange height of .375" above my finished floor, counting my mortar. Will a closet flange with a...
My toilet is raised about six inches off the floor and I would like to make it flush
[ 2 Answers ]
My toilet is raised about six inches off the floor on a square pedestal and I would like to remove the pedestal and make the toilet flush with the floor. We live in an older mobile home and have recently been told by a plumber that this isn't possible without spending quite a bit of money - which...
Raising toilet flange 4 inches
[ 0 Answers ]
Building bathroom in basement. Drain of bathtub is 6 ft away from drain in concrete. I'm adding a 2x4 sub floor, need to raise the toilet 4inches This sub floor is hiding the drain. Thanks Sigi
Toilet replacement and floor height change
[ 1 Answers ]
I am going to be setting a new toilet in our addition and need help. I needed to level the floor as there was over an inch and a half between the old and new areas of the bathroom. After all is said and done, the old cast iron flange is almost two inches below the new floor height. During... View more questions Search
|