Ask Experts Questions for FREE Help !
Ask
    ddwentzell's Avatar
    ddwentzell Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 12, 2014, 12:24 PM
    How do I find an OPS/OSHPD panel box?
    I usually supply a standard Cutler-Hammer breaker box with our equipment (when required). I have a customer insisting on using an OSP panel box. I can't find one.
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #2

    May 12, 2014, 01:41 PM
    Never heard of an OSP panel box. What is it?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Circuit panel box [ 3 Answers ]

What steps do I need to install a new circuit panel box

I need help replacing an old Fuse Box with a new Panel/Breaker Box [ 3 Answers ]

I need to replace my old Cutler Hammer Main fuse box with a new 100 Amp Pannel/breaker box & there are several legs of conduit running from the old fuse box. Two on the bottom, one on the top & one on the side! One coming out from the bottom is the main supply coming from the meter outside with the...

Junction box under panel box? [ 1 Answers ]

I am bringing new underground cable into an unfinished garage which is coming directly from the meterbase. The cable will come out of the ground at the garage, run up the outside of the wall for approximately 3 feet (obove the 2 high cinderblocks) and then go through the wall where it will connect...

Panel box [ 1 Answers ]

We have a 200 amp service entrance. We are wanting to add to house, and wanted to see what to do about breaker box. Our 200 amp box is almost full now ( but there is room for additional breakers we need ) and we would have to add at least 1- 30amp for water heater, 3- 15amp for recepticles and...

View more questions Search