Ask Experts Questions for FREE Help !
Ask
    big962003's Avatar
    big962003 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 23, 2014, 09:30 PM
    Add a motion detector to existing light w/integrated detector.
    I have a light with a motion detector on-board. Would it be possible to add another detector, away from the light fixture, and still keep the one that is on the light functional?
    smearcase's Avatar
    smearcase Posts: 2,392, Reputation: 316
    Ultra Member
    		  
    #2

    Apr 24, 2014, 03:52 AM
    This may be a possibility:

    Add-On Motion Sensor for Motion-Activated Security Light, Motion-Activated Lighting Control - HS2144 - Smarthome
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to add two motion sensors to existing light circuit? [ 14 Answers ]

I have a circuit with a single switch connected to four outdoor lights. I would like to add two motion sensors so that either of them will trigger the lights to go on. Can someone please help me with suggestions and/or a wiring diagram? The motion sensors I have are like this one: Link. They...

Adding a separate 2nd light fixture to a motion detector [ 15 Answers ]

I'm having problems with connecting a 2nd light fixture to one motion detector. The motion detector is rated to 500 watts and has 2 lights. Because of the lack of coverage I wanted to add a 2nd light fixture to flip on when motion is detected. When I connected everything together, the 2nd light...

Motion Detector For Existing Oudoor Light [ 3 Answers ]

I have an NEW light outside above my garage door. I would like to add a motion detector, perhaps adjacent to this light. My old light was easy because the detector I bought had two parts, one the detector itself which I attached adjacent to the light, and a part which screwed in to the standard...

I want to add a motion sensor to an existing circuit. [ 3 Answers ]

I have three exterior lights, which are controlled by one switch inside. I would like to add a motion sensor to control all three lights. I don’t want to use the inside switch anymore. Is it possible to add the motion sensor and if so where should it be added. Could someone please give me detailed...

Motion detector for a flash of light [ 3 Answers ]

I want to construct a motion detector that will fire lights and a horn on a car grill and fender for a halloween effect. I only want it to last 3 -5 seconds then turn back off. Can you help me with a design?

View more questions Search