Ask Experts Questions for FREE Help !
Ask
    kimmysharp's Avatar
    kimmysharp Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 10, 2007, 12:52 PM
    Kenmore washer
    Why is my kenmore washer agitator (the top part) not working?
    RalphS's Avatar
    RalphS Posts: 120, Reputation: 12
    Junior Member
    		  
    #2

    Apr 10, 2007, 10:21 PM
    If you are talking about the large plastic center "screw" of the agitator not pulling the clothes down, there are 4 small cogs under the center cap that are worn. You'll have to remove the center small bolt in the center holding the agitator to the trans shaft, lift off the agitator and take it apart. Pick up a new set of cogs and replace then then reassemble everything you took apart.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore washer dryer combo 110-92966-102,washer agitates for a little then it stops. [ 0 Answers ]

Kenmore washer dryer combo 110-92966-102, The washer will fill and it will agitate for a little bit for about a minute, then it will stop before finishing.When it stops there is no motor sound.No matter what I set the knob to it will not start up again,but if I wait several minutes it will...

Kenmore washer [ 1 Answers ]

My kenmore washer makes a clicking noise when it goes into spin cycle. What is causing this?

Kenmore 70 Washer [ 1 Answers ]

The washer does not spin. How do I remove the top. Any other advice?

View more questions Search