Ask Experts Questions for FREE Help !
Ask
    mella66's Avatar
    mella66 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 10, 2014, 10:15 AM
    I need a correct part # for gasket drain in shower 1019nc/abs-11apmo
    I have a leak in my shower drain, took off ceiling where leak was. Shower is on second floor. Want to remove gasket tried pliers no luck part number I found is: no-101pnc / abs-1 1apmo went to plumbing store they needed, want be sure this is the correct number or my shower drain. Thank you for your help

    Carmella
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    Apr 10, 2014, 12:30 PM
    Hi Mella

    That looks like a number associated with the OATEY NO-CALK shower strainer...check it out here:

    Amazon.com: Oatey 42077 101 PNC ABS NO-CALK Shower Drain with Plastic Strainer, 2-Inch: Home Improvement

    That part may be available at the local plumbing supply store, or it could be at home depot or lowes.

    Mark
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can an Oatey ABS No-caulk shower base drain be used with a copper drain pipe? [ 5 Answers ]

I am replacing a free standing Spartan shower with an inexpensive Swanstone free standing shower. The Swanstone comes with an Oatey ABS drain. My question is: can this plastic drain be used with my copper drain pipe? The pipe is extending up over the cement floor by an inch. I believe that I must...

Correct pvc shower drain for sterling #62040100 60" seated shower receptor [ 6 Answers ]

Has anyone installed a sterling 60" seated shower receptor with wall surrounds on a concrete slab. The new unit did not come with a shower drain. there is a hole in the bottom That is 3-5/16" (8.4cm) and it calls for a drilled hole in slab oor foundation of 4-1/2" (11.4cm). the old drain line...

Shower Drain Gasket replacement [ 11 Answers ]

How do I get to the gasket in a stand up shower to replace the gasket? I am using a pair of channel lock pliers, handles down the drain and turning... I don't seem to be making any progress other than tearing the grips of the handles of my pliers. Any suggestions? :confused:

Basement shower abs drain pipe [ 3 Answers ]

In my basement roughin the abs drain pipe is not quite plumb, can the abs pipe about 5 or 6 inches from the p-trap, be flexed slightly to line up with the shower drain tail piece? The drain tailpiece I'm using is a B&K Industries with the rubber sleeve that slides over the 2" drain pipe then a...

View more questions Search