Ask Experts Questions for FREE Help !
Ask
    dubhain1's Avatar
    dubhain1 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 4, 2014, 05:25 PM
    ICM275 circuit board installation
    I have a Carrier 58sx060 furnace. I just replaced the circuit board attached the wires were they're supposed to go but the fan only runs continuously even when thermostat in set to auto with no heat. Does the new board need to be reconfigured somehow or what could I have done wrong?
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Apr 4, 2014, 08:04 PM
    Review your installation by checking it against the manual here: http://s3.pexsupply.com/manuals/1266..._PROD_FILE.pdf

    There is a troubleshooting section toward the end of the manual.
    dubhain1's Avatar
    dubhain1 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Apr 5, 2014, 09:04 AM
    Well if I tested it correctly the voltage is less than one. How do I fix it?
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #4

    Apr 6, 2014, 04:20 PM
    Voltage measured where?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Installation of wonder board over brick [ 1 Answers ]

Can you install wonder board over brick wall in a bathroom .If so how would should I go about it.

Icm275 problems [ 0 Answers ]

My day&night high speed fan goes on and off every 30 seconds when the thermostat is on cool and auto even when the room temperature is below the "set" temperature.. This happens at night only. I already changed the termostat, the termostat wire, the icm275 board, and bypassed the heat sensor (off...

Circuit Board [ 5 Answers ]

When I had an Amstrad 6128 I remember playing a game "Purple Saturn Day". One of the challenges it had, was a puzzle game on some kind of circuit board (see photo 1). I'd like to know if there are any puzzle or strategy games available, where you have to complete a circuit board or transfer...

Circuit board [ 15 Answers ]

Hello all. New at this site and loving it. Thanks for having me. My question is this. I'm having trouble with a disco light. This guy came in and dropped it. He says there might be wrong with the ic chip or it could be fuses. OK first things first I replaced all the fuses with new ones....

View more questions Search