Ask Experts Questions for FREE Help !
Ask
    bluemoon13's Avatar
    bluemoon13 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 4, 2014, 09:41 AM
    Modine Heater won't start
    I have a Modine 150,000 BTU propane heater in my greenhouse, brand new installed 2 weeks ago, and today it is not starting. Checked the thermostat, wiring to power source and all checks out, but I'm not getting anything--no burners, no click of ignition. Any thoughts or things to check? Thanks!
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Apr 4, 2014, 07:54 PM
    If you had it professionally installed, call the installing company. If you installed it yourself, take out the install manual, & start from scratch. If all seems well there, get out the voltmeter & start tracing to see where power is being lost.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Modine gas heater is not producing any heat. [ 0 Answers ]

My pilot is lit just fine. The fan comes on but no heat at all. Replaced the thermostat but I don't understand why burners will not light

MODINE 75k nat gas Heater won't start need help troubleshooting [ 8 Answers ]

I have had 3 great winters since I(me) installed this unit but today the exhaust fan runs but igniter never clicks plus no main blower. I bypassed the thermostat, that's not it.the troubleshooting charts are too veige for this DIYer.I don't want to replace an ignition controller if I don't have to....

Modine Gas Heater: Power exhaust-Condensation/Drain? [ 1 Answers ]

Modine PDP200 Natural gas heater with power exhaust. 6" galvanized, approx 15' exhaust through roof. Condensation/rust after two years. Replacing exhaust duct. Question if condensation drain/trap required or recommended? Double wall or single wall OK?

MODINE Furnace start and stops [ 5 Answers ]

MODINE hanging (pipe) Shop Furnace 55,000 BTU Flame starts, blower comes on about 30-45 seconds later. Flame shuts off at about 3 Minutes, blower continues to run about 5 min. Then cycle repeats. Side note: Have replaced Thermo Coupler last year and blower this year ( about 15- 20 years...

View more questions Search