 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Furnace
1 blink code for ignition failure. Relight furnace with no problem. Heat comes on. 15 min or a couple of hours goes by and once again cold house with a 1 blink code. Start process all over again. And over and over. Furnace lights every time but won't stay lit. Please advise.
|
||||
Check out some similar questions!
Furnace fires up just fine, and fan spins but there is absolutely no airflow in duct work. Any ideas? Last spring thermostat went out and I replaced it, worked great. A month later circuit board burned out, tech found that problem and replaced it (major pocketbook ouch) and everything worked...
I have a Trane XE78 furnace and the flames come on for about 5-10 seconds and then shut off. They re-ignite about 10 seconds later, then shut off 5-10 seconds after the 2nd ignition. I believe they flame on one more time, shut off and then never re-ignite and the blower just runs and runs with...
I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.
I have an Armstrong forced air (induced draft) natural gas furnace with central AC (made around 1990 -- Model: EG6H80DC14-1, Serial: A18315MNA). I had a problem at the end of the heating season where the blower motor would run continuously (even when the thermostat is turned to "off"). I thought...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
