 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
The inducer blower motor plastic fan (fasco a164) keeps failing every month. Why?
My inducer blower motor fan on my furnace is failing every month. It is plastic and a fasco a164 model. I have had the combustion tested and it is OK. Is there any other causes that would lead to this premature failure of the fan (the actual motor is fine)?
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
A Lennox 67k0401 combustion inducer motor was recently replaced with a Fasco A163 motor. After the inducer motor starts. There is a pause about 5- 8 seconds then it runs OK. Is The motor defective? What's causing this?
My 1997 Nordyne/Miller furnace Model G5RC-060C-12, G5R9606-01232 stopped working and signaled 2 red-blinking lights--pressure switch open. I checked tubing for kinks and blockage-none found. I cleaned condensate tank and re-filled with water. Air filter is new. I shut down furnace. Next morning...
There are two plugs side by side at the top. The top one on the left side has a yellow cap and the right side is uncapped. The one plug on the bottom has a yellow cap. Should they all be capped?
I have a Bryant Plus 90 high efficiency furnace, Model 398A, about 14 years old. I am now on my third inducer motor assembly. The plastic blowers on the first two disintergrated. Does anyone have any idea as to why and what can be done to prevent another failure? Besides the inconvenience of no...
What is the purpose of the plastic “condensate drain plugs” on the Fasco D728 furnace blower motor? I needed a replacement for a GE motor 5KCP39PGP932AS 3/4HP for my American Standard Furance . On "Ask A Question", I found the reply from “HVAC1000” to “rtlalonde” that had a hyperlink to the...
View more questions Search
|
