Ask Experts Questions for FREE Help !
Ask
    petmee's Avatar
    petmee Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 12, 2014, 03:05 PM
    Carrier furnace
    Carrier model 58 pav flashing red light does not flash. Has 110 ac to furnace.reset black switch behind door and still no red light code.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Feb 12, 2014, 07:19 PM
    I'm not sure if that light is 120 or 24 volts. Look for a small automotive type fuse (probably 3 or 5 amp). Remove the fuse & inspect to see if it is blown. If so, replace with a new fuse & try again. If the fuse is good, the board is probably bad.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier furnace: limit switch fault furnace has ignition but blower will not come on? [ 2 Answers ]

Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?

I have a Carrier Infinity gas furnace. The furnace goes on and off many times before [ 1 Answers ]

My carrier infinity gas furnace goes on and off mmany times before it reaches the set temp. It has a two stage blower motor. The unit is only three years old. Board and thermostat have been replaced.More intake ducts added. None of this helps

Carrier furnace 58rav115-16 blower runs but furnace will not ignite [ 0 Answers ]

I have a 58rav115-16 caarrier unit. Lst week I replaced a suspected bad draft limit switch(code31) ran fine after. This morning I got up and the blower was running but it would not ignite. I switched to emergency heat and received a code31. I bypassed the draft switch and was able to get the them....

Carrier Furnace [ 4 Answers ]

I am looking at furnace for a friend. The furnace will come on with that small fan and the pilot will light. However, the burner will not catch. This unit has a igniter I suspect that the igniter is bad. Is there any way to test it?

View more questions Search