Ask Experts Questions for FREE Help !
Ask
    ostoughton's Avatar
    ostoughton Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 6, 2014, 09:55 AM
    1992 Heil 7000 furnace
    Last night I touch two red wires and a part fell of my furnace. I was able to put the part back on but it must be broken to come off that easy. I think it is called a flame rollout switch or sensor. Should this fall away from its location?
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
    		  
    #2

    Feb 6, 2014, 10:10 AM
    Hi ostoughton and welcome, the rollout switch should have a mounting screw. How did you put "the part back on"? What were you doing in the combustion chamber anyway?
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #3

    Feb 7, 2014, 08:13 PM
    The switch may have simply fallen apart. I've had it happen several times. The switch needs to be replaced.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

HEIL 7000 furnace [ 0 Answers ]

Furnace won't stay lit iv'e tried jumping limits and roll over switches volt meter reads 24 volts what should I do could it be the gas control valve?

HEIL 7000 gas furnace with 2 questions [ 0 Answers ]

Gas ignites stay lit till blower fan turn on then gas flames shut off. Then when calling for more heat same thing happens. Also, noticed some water/moisture in my draft inducer fan housing. Is the moisture normal since it does have hoses connected to it? Many thanks for the help. Rich

7000 Heil Furnace [ 1 Answers ]

My Heil 7000 furnace, installed new in 1993, is leaving a wet spot on the floor just below the lower right panel edge. When I slide my finger along this lower right edge, there is accumulated water, which is dripping ever so slowly, causing the wet spot. What might be the cause of this never before...

Troubleshooting heil 7000 gas furnace [ 1 Answers ]

On initial start up on my Heil 7000 furnace it is making one heck of a noise until the blower comes on at which time everything is normal. Heater is working perfectly at that point. Do you have any ideas?

Heil 7000 furnace, blower stays on and burners don't ignite [ 14 Answers ]

Furnace Info: -Upflow Condensing Gas Furnace is a Heil 7000 (model# NUGK075DG09) -Electric spark or host surface ignitor ( I think it's spark) -Installed Oct. '96 (when we built the house) -90% efficiency -wall thermostat is honeywell programmable. Don't know model but was also purchased in...

View more questions Search