Ask Experts Questions for FREE Help !
Ask
    harleydog959's Avatar
    harleydog959 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 4, 2014, 03:20 PM
    York gas heater troubleshooting
    I have a york gas furness. When I turn it on, the ignighter turns red then the gas turns on and the unit works. It starts running for about I minute the shuts down. Have cleaned everything I know to clean and has a new exhaust motor. Am lost now
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
     
    #2

    Feb 4, 2014, 09:00 PM
    On most furnaces there is a circuit board which will blink a code. Often the light is visible through a window in the blower compartment door. If yours has such, count the blinks then remove the blower door & on the inside you should find a key to the code. Report here the meaning of the code & we can probably help.
    Have you cleaned the flame sensor rod?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troubleshooting york gas heaters [ 0 Answers ]

Single family Gas whole house heater(York)!When calling for heat it goes through the initial steps!Thermostat calls for heat. The ignighter glows bright orange! The burners light!Then a moment later go out!This sequence repeats itself then the blower motor comes on and then it pushes cold air...

York gas furnace troubleshooting [ 5 Answers ]

I have a couple of problems with my York gas furnace. First, it has a # 8 fault code which from what I understand is caused when the flame is lost 5 times. My second issue is that one of my burners is lazy and I think my heat exchanger is cracked. Does anybody have experience with that code and...

York gas furnace troubleshooting [ 3 Answers ]

I have a 15 year old York Stella-Plus gas (propane) furnace. The system operates a few minutes and then immediately shuts off. The propane dealer (who originally installed the furnace) has been out 6 times this last heating system. They have replaced the flame sensor, flame ignitor, burners, 3...

York heater troubleshooting [ 10 Answers ]

I have a york diamond 90 model P3UR When I raise the temp, the blower goes on, then I see the pilot get hot ( glow ), then blower goes on for about 30 seconds and shuts off. This goes for 3 cycles then stops. Tried cleaning the flame sensor... still does the same thing Can anyone help? Thanks

York heater troubleshooting [ 2 Answers ]

I have a york diamond 90 model P3UR When I raise the temp, the blower goes on, then I see the pilot get hot ( glow ), then blower goes on for about 30 seconds and shuts off. This goes for 3 cycles then stops. Can anyone help? Thanks


View more questions Search