Ask Experts Questions for FREE Help !
Ask
    paintmankeith's Avatar
    paintmankeith Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 1, 2014, 11:23 AM
    Vanguard Heater Adjustmsnt
    How can you adjust the pilot light on a Vanguard heater.. It is too high...
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Feb 1, 2014, 12:34 PM
    Standing pilot gas valves typically have a pilot adjust screw. Look for a small button cap or screw cap, possibly marked "Pil Adj". Remove the cap and see if there is a small screw underneath. Tighten down to lower flame.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Vanguard gas wall heater [ 1 Answers ]

Had a hvac company come to fix my vanguard gas wall heater. Problem the pilot light would not stay lit. They said all it needed was cleaning. They said they cleaned it and I thought they had fixed the problem; until the same evening approx 6.2 hrs after they left the pilot light went out again....

Pilot Light on Vanguard Gas wall heater [ 3 Answers ]

I am unable to get the pilot light to light. I cheked and there is sufficient gas in tank. I have tried blowing dust off pilot light. My ignitor sparks but pilot will not light. Any ideas about what may be wrong?

Vanguard 16 hp [ 4 Answers ]

I have a 16 hp vanguard in a 96 wacker compactor, can get it started for a short period using carb and choke cleaner,I cleaned carb, is there anything else that could be wrong, it ran fine last fall, we did put seafoam in it prior to winter storage. Also need an owners manual, any idea?

Vanguard 16 vs 18 hp [ 1 Answers ]

Will a vanguard 18 horse engine directly replace a 16 horse version? This is a vertical shaft in aSimplicity mower.

16 hp vanguard [ 1 Answers ]

I have a B/S model 303777 it will only run on full choke line from tank is clear and fuel pump is working. Could it be the fuel solenoid on bottom of carb and is there a way to check it thank you

View more questions Search