Ask Experts Questions for FREE Help !
Ask
    jonif2007's Avatar
    jonif2007 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 29, 2014, 11:56 AM
    Furnace no flame no gas
    My furnace is just over 3 years old and this morning stopped working I changed the filter.. it was pretty dirty:( I know that's bad but the blower will come on but no heat so took panel off noticed that the motor wasn't spinning so got that too work furnace tried to work but still no heat... seems like no gas is coming out tried 3 times and gave up.. I reset and turned off the power.. my question is that what would cause no gas?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Jan 29, 2014, 12:13 PM
    Bad ignitor, bad high temp switch, tripped rollout switch, bad gas valve. If the ignitor doesn't come on, and you had a dirty filter, I would check the high temp limit switch.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gas furnace flame timing [ 7 Answers ]

I have a Goodman high efficiency gas furnace which is about 8 years old. It seems to be working fine. I had it cleaned by a technician today. He observed that the flame stays on for a couple of seconds after the power is shut off and that this is dangerous and needs to be rectified. He recommends...

Gas furnace - no flame [ 4 Answers ]

Hope someone out there can help, because it's going to get cold this weekend! I have a split HVAC unit with furnace in attic. Written on front of unit is Intertherm. Inside panel of unit says Nordyne, and the Ignition Control is Robert Shaw. The unit is 13 years old and the heat worked fine...

Gas furnace, fan works, but no flame [ 2 Answers ]

I have a gas furnace. House is 55 degrees. Thermostat is set at 80 degrees, switch on furnace is in on position and fan/blower works, Gas is present in hot water heater 24": away on same line and stove works in kitchen. Breakers are OK. Furnace does not light. No gas smell. Help!! ...

Furnace blower will not stop after flame goes out on gas furnace [ 1 Answers ]

Furnace blower will not stop after flame goes out on a gas furnace

Gas furnace, intermitant flame [ 1 Answers ]

I have a Day &Night gas furnace and the gas flame will stay on for a few seconds and then shut off for several seconds. The pilot stays lit and the thermostat calls for heat. The blower continues running as the flame cycles. Any idea where to start trouble shooting? Thanks for any help, Greg

View more questions Search