Ask Experts Questions for FREE Help !
Ask
    tom0704's Avatar
    tom0704 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 26, 2014, 08:42 AM
    Hotwater101.
    My gas water heater will not ignite. Can I light the pilot with a match?
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    Jan 26, 2014, 10:27 AM
    Better to try using fireplace matches, a barbecue igniter, or even a small propane torch...something with length. If that fails to light your pilot then, most likely, the THERMOCOUPLE is defective and will need to be replaced. This is usually a quick job, but time to fix will depend on the exact model and age of your water heater!

    Mark
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hotwater101 [ 1 Answers ]

It takes too long for the water to get hot from any faucet??

Hotwater101 [ 2 Answers ]

How do I drain a water heater?

Hotwater101 [ 1 Answers ]

Just installed a whirlpool electric hot water heater and have minor leak at top nipples. Used tephlon tape on threads and tightened as tight as possible. Any suggestions. I have taken off and reinstalled which minimized leak but still "bubbling"

Hotwater101 [ 1 Answers ]

I have a 40 Gal Wirepool Hot water Heater. It was not lighting up this morning. They are mailing me the assembly for Thermo Cuple and other parts. How do I install that?

Hotwater101? [ 0 Answers ]

I have a new 40 gal. "Gas" H/W heater installed about 4 weeks ago by a professional. It worked fine up until about a week ago, then the pilot began going out and would not re-ignite until I disconnected the 2 leads which I assume are connected to the piazo/thermocouple. Once I did that, then...

View more questions Search