[afilliol]

Water tank broke I changed it to a brand new one from home depot. After I changed it I did not have too much water pressure in my main bath you turn bath tub on it comes out very slow you turn sink on to hardly any water. I was told the line is probably plugged I pulled the facets nothing blocking it I disconnected the hot water tank from the manifold put a wire up there nothing came out so I went and ran new lines straight to the bath tub off the manifolds buy them self's it did not change any thing can you help

[massplumber2008]

Hi Afilliol

What kind of tank? A hot water tank, a bladder tank for a well system, what? If this is a bladder tank then the bladder tank needs to be pressurized to 2LBS below the cut on pressure setting of the pressure switch.

If you are talking about a well system bladder tank, check out this link and scroll down to the post by HKSTROUD:

https://www.askmehelpdesk.com/plumbi...er-780149.html

As much as that thread is about excessive pressure it still applies to you in setting proper pressure to your well system (if you have a well).

Otherwise, let us know more info. here, OK?

Mark

[hkstroud]

Could you tell us what you mean when you say that your old tank "broke".