 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Low water flow
I have a Glacier Bay single-handle kitchen faucet. The water pressure has decreased over time until it now is nonexistent. I have checked the screen and it is clean. I blew out the sprayer line. What is my next step to try to increase water flow?
|
||||
|
||||
|
Shut the water off and then disconnect the supply tubes to the faucet...if the lines are flexible, direct each one into a bucket and turn the water back on...how is water flowing from these supply tubes? If you get good water flow then the cartridge in the faucet is clogged (remove and clean or replace).
If water flows poorly, then check the shutoff valves under the sink...trace issue back from there if needed! Mark |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
In one bathroom the water flow in the sink is very low including the shower. Also the kitchen hot water is very slow but the other bathroom is working great. What's wrong, please help thanks
I just had my water heater replaced by a plumber. Now the hot water flow and pressure is about 1/4th of what it used to be at the upstairs tub faucet. Other faucets in the same bath seem low as well but it is hard to tell. The bath tub faucet had great flow before and would fill the tub in 5...
My home was built in 2005, I have a shower/tub combo that has only been used once since it was installed. I recently had issues with hearing sucking/draining noise coming from the drain in this bath when toilet was flushed, I discovered the water in the trap had evaporated.. Easy fix! But when I...
I recently moved into a house that is about 6 years old. The house sits upon a small hill. The water pressure is 40 psi at the street and the flow rate is 13 gpm. At the house, the pressure is about 30 psi and the flow rate is 3.5 gpm. The house is higher than the street level, but the...
View more questions Search
|
