Ask Experts Questions for FREE Help !
Ask
    woodfc's Avatar
    woodfc Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 28, 2013, 04:10 PM
    PAYNE furnace 373LAV036055
    My 20+ old furnace fan/blower will not work. The furnace starts and heats up just fine but the main fan/blower will not come on. I have trouble shooted the circuit per my manual and have no 110V power coming out of the control board.

    Do I need a new control board or is there another switch in the circuit that is keeping the fan from running?
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Dec 28, 2013, 04:33 PM
    If you have power coming out of the fan terminals on the board, you probably have a bad fan motor. Could be as simple as a bad capacitor.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Payne furnace no heat? [ 1 Answers ]

I have a Payne (propane) furnace. It goes through the self test fine but when I run it for heat, only the main fan comes one. The Igniter does not come on and no Heat. Can anyone help me with this problem please? Thanks in advance.

Payne gas furnace? [ 0 Answers ]

My furnace was bought in 1995. I want a high efficiency gas furnace, will they have to put In new duct work for a new furnace or can they just use the old stuff

Payne Furnace [ 0 Answers ]

I have a payne furnace that when the thermistat kicks on the furnace fires up the first stage and glows orange. After a minute you hear a click and sometimes it goes into the next stage with the blue flame and some times after a couple of clicks it just turns off. Then I have to drop the temp and...

New Payne furnace overheating [ 2 Answers ]

I had a new Payne furnace model PG8MAA042090 installed a couple of weeks ago. It has not worked consistently since it was installed... keeps shutting off. Incidentally, we replaced the thermostat at the same time with a Honeywell programmable model. One company came out and replaced the limit...

Payne gas furnace not getting enough [ 3 Answers ]

Gas furnace is to draw combustion air from outside. Installation allows compution air to be feed into the furnace from the left or the right and provides a plug for the unused side. With the plug installed furnace tries to run but the pilot light gets blown out. Leaving the plug out the furnace...

View more questions Search