Check out some similar questions!
Intertherm Furnace Troubleshooting E2EB015HB furnace kicks on when suppose to and off
[ 1 Answers ]
Furnace kicks on and off when suppose to but when blower shuts down the heating element doesn't have to flip switch to shut off element
Intertherm furnace codes? This furnace flashes the yellow light 6 times
[ 0 Answers ]
Furnace will run for 30 seconds. It shuts down and the yellow light will flash 6 times and the does the same thing over and over. Red light stays steady. Thanks for the help.
Intertherm M1MB hot surface ignitor powers up, burner comes on and then shuts down
[ 1 Answers ]
Interthem L.P. gas M# M1MB 090ABW ignitor lights up, burner comes on and then in two seconds everything shuts down. The entire process repeats itself again. Board electronic yellow LED (burner) light never comes on and the red LED glows continuously. Not sure if board is bad. Unit has been running...
Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks
[ 3 Answers ]
I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.
My intertherm furnace pilot lights but furnace won't kick on
[ 5 Answers ]
I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH... View more questions Search
Add your answer here.
|