Ask Experts Questions for FREE Help !
Ask
    jonnywad's Avatar
    jonnywad Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 2, 2013, 11:31 AM
    Problem with Intertherm Furnace
    My furnace was running when the power went o
    Ut and now it won't turn back on
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Dec 2, 2013, 08:35 PM
    There is probably a manual reset limit switch on or near the blower. This will be a small switch with two wires & a button between the two wires. If you push the button down & hear or feel a click, it had tripped & you were able to reset it.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Problem with intertherm furnace [ 0 Answers ]

Intertherm furnace goes on then blower cycles off and on

Problem with Intertherm Furnace, blower stays on all the time [ 1 Answers ]

I have a intertherm furnace and the blower motor stay on even if I shut it off at the stat, the only way I can shut the motor off is at the breaker. I think the fan limit on the furnace is bad, can some one enlighten me

Intertherm furnace codes? This furnace flashes the yellow light 6 times [ 0 Answers ]

Furnace will run for 30 seconds. It shuts down and the yellow light will flash 6 times and the does the same thing over and over. Red light stays steady. Thanks for the help.

Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks [ 3 Answers ]

I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

View more questions Search