 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Airco furnace
I have an airco furnace and was attempting to change the thermostat. I connected the 2 wires to the new unity (Black & White) turned it up beyond the normal household temp. It came on for about 90 secs and shut off. It seems to repeat this process every 20 or 30 minutes but will not keep the burners on. The pilot light is on and the thermo coupler appears to be OK. Possible solution?
|
||||
Check out some similar questions!
I have an Airco 2-Stage furnace that was working fine with a Lux thermostat. I changed the thermostat to a Honeywell WiFi thermostat so I could control it remotely. After installing the thermostat based on the install instructions it weemed to work fine until the 2nd stage kicks in on the...
Main blower on furnace, is not running, when thermostat calls for cooling the out side unit runs. The main blower on the furnace in not
We have an old airco furnace and we need to replace the filter, however the one in is the wrong size and needs to be bent in the middle. Which one do we need?
AirCo furnace with fanlimt , indujcer and ignition control kicks on and goes for approxtimatly 10 min then the venting rollout trips . Replaced the inducer and the venting rollout however the problem still there . Inducer close the pressure switch and the manometer shows .70" wc out of the...
I have an Armstrong forced air (induced draft) natural gas furnace with central AC (made around 1990 -- Model: EG6H80DC14-1, Serial: A18315MNA). I had a problem at the end of the heating season where the blower motor would run continuously (even when the thermostat is turned to "off"). I thought...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
