 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Pressure sensor switch related. Could be a bad switch, blocked vent, air intake or blocked air hose. Disconnect hose from plenum and make sure plenum and sensor holes are open. After cleaning out, turn off heater power for a couple of minutes and then restart.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a York Diamond 80. Will not light. Have done some research on here, cleaned the flame sensor, still no luck. Failed to ignite and locks out after three tries. What is the next step. What do I check? If anyone can help, great. Thanks
Hello, I have a York (forced air) gas furnace that's 9 years old. Every winter it seems like I have to replace the pressure switch ( round switch with 2 connections & air hose). I hear the blower come on, burners ignite and then within a few seconds they go off with the red light flashing 6 times....
I have a Carrier and the furnace and the heat will not come on. The fan does come on but the burners will not ignite. I get a red flash code of 2 short and one short. I have the same thermostat upstairs and I switched them and the same result. The upstairs works fine with both thermostats. I have a...
I have a york furnace model gy9s060b12up11k. Flash code is 12 flashes. The burner fan comes on then clicks off. Igniter does not come on but blower fan stays on. No heat. Any ideas?
Hi, I have a 6 year old york furnace that doesn't seem to be working anymore. The burner turns on for 20 sec each time up to 3 times then goes out. I took out the ignition sensor and cleaned but doesn't seem to work. When I look at the error code, it gives me 6 flash lights. Any Help would be...
View more questions Search
|
