Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Goodman GMH furnace motor won't run
[ 9 Answers ]
Motor runs when wired direct to door switch, would it be the relay or the control board? How could I figure out which Thanks
Goodman furnace 075 exhaust motor doesn't run
[ 1 Answers ]
I have a Goodman Furnace 075-3. It recently stopped blowing heat and would just blow cool air. I took the top cover off and confirmed that there was no flame. The gas valve to the furnace is turned on and the switch inside the top cover is also turned to the on position. There is a single light...
The furnace will run for 3 min then the relay kicks out
[ 6 Answers ]
I have repalced the nozzol and the fliter at the tank the way it look like it was never changed... so if I hold the reset button down it will fir up and run for like 3 minutes then it just kicks out and the red light comes on... I have bleed the air out so that's not the problme and this is the...
I have Goodman GMP100 furnace. The vent blower won't run
[ 1 Answers ]
On the Goodman GMP100 furnace, the vent blower tries to run but stops immediately. The status light blinks 3 times. Is there a way to find out if the vent pressure switch is defective?
6yr old goodman furnace won't run.. had ignitor replaced in 04, could it be out again
[ 1 Answers ]
6yr old goodman gmt090 running this morning at 830, left house came back 230, house cold reading 57 degrees. Had ignitor replaced in feb of 04, could it be out again.. View more questions Search
|