Gms80904bncb not lighting

caringhands Posts: 1, Reputation: 1

New Member

Nov 20, 2013, 07:47 PM

Gms80904bncb not lighting

I'm getting no power out of the ignitor board to the Ignitor. The board is new and it's hot just not on the wire I need. The blue wire going to the Ignitor has no power.

Check out some similar questions!

Need light fixture for a obsoleted Progress Lighting 3 circuit track lighting system [ 1 Answers ]

I have an operating Progress Lighting 3 circuit tracking system that has one broken light fixture of its seven fixtures that are still operating.I need a replacement fixture since one is broken. Where can I try to get one? Thanks, Tom Madison

Pilot is lighting on home heater but no hot air and pilot is lighting but it continue [ 0 Answers ]

Here is my problem The hot air is not coming out from a/c ven Heat was working two days ago Pilot works but it starts then goes out or low then starts again but gas to burner doesn't start main burners for heater Tried circuit breaker and on/off switch and pilot screw adjust which did not...

Dj lighting [ 1 Answers ]

I'm a music dj, I have a circuit box with 8 channels that say I can put 10 amps per channel. The box says I can it has a 15amp breaker. The question I'm asking is can I put a total of 80amps since I have 8 plugs?

Lighting [ 2 Answers ]

I apologize in advance for my lack of knowledge. In my basement I currently have a single 20A circuit with 6 lights on it, rated at 150W each, controlled by a single light switch. I'd like to know if its possible to break these lights up without adding circuits. Is it as simple as adding a...

View more questions Search

Check out some similar questions!

Add your answer here.