Ask Experts Questions for FREE Help !
Ask
    Samosa's Avatar
    Samosa Posts: 13, Reputation: 1
    New Member
    		  
    #1

    Apr 5, 2007, 01:55 PM
    Kenmore washer centrifugal switch
    What is the purpose of centrifugal switch
    RalphS's Avatar
    RalphS Posts: 120, Reputation: 12
    Junior Member
    		  
    #2

    Apr 6, 2007, 09:29 PM
    Quote Originally Posted by Samosa
    what is the purpose of centrifugal switch
    The ONLY reason for a centrifugal switch (Inside the drive motor) on a top load washer is to disconnect the "start" winding after the rpm's of the motor are sufficient to operate on the "run" windings alone. :D
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore washer dryer combo 110-92966-102,washer agitates for a little then it stops. [ 0 Answers ]

Kenmore washer dryer combo 110-92966-102, The washer will fill and it will agitate for a little bit for about a minute, then it will stop before finishing.When it stops there is no motor sound.No matter what I set the knob to it will not start up again,but if I wait several minutes it will...

Kenmore 70 Washer [ 1 Answers ]

The washer does not spin. How do I remove the top. Any other advice?

View more questions Search