Ask Experts Questions for FREE Help !
Ask
    rajnel2's Avatar
    rajnel2 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 12, 2013, 10:58 AM
    Furnace with new pressure switch will not start
    Good day, 2 weeks ago I replaced the pressure switch in my furnace. It is a Lennox Model C33 - 31A - 2F - 2. The furnace ran fine and then stopped cycling. If I unplug one side of the pressure switch, the inducer starts, then plug it back in and the furnace will heat until thermostat kicks off. Then it will not cycle again unless I repeat the above. Please help.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Nov 13, 2013, 09:02 PM
    Sounds like the pressure switch is sticking closed. The most common cause of this is moisture getting into the switch.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heil gas furnace--replace air pressure switch but won't start [ 0 Answers ]

Model NTGM075EGA3 Heil gas furnace I replaced the air pressure switch per serviceman advice but am not sure if the furnace is supposed to automatically startup ? It didn't. How do I know if it has a pilot light? I see no pilot button to push. This furnace is about 12years old. If it has a hot...

My gas furnace is not getting vacuum pressure for the pressure switch. [ 1 Answers ]

All the hoses were replaced as well as the pressure switch it self. I can jump it and it fires right up. It's a Heil model. The pilot light lights automatic. If you take the hose off that goes to the pressure switch and suck on it, it switches and the pilot light lights off. I don't know much...

York residential furnace pressure switch problem code stuck switch [ 1 Answers ]

I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals

What pressure should a pressure switch on a furnace be? [ 2 Answers ]

How many inches of water column should a furnace's pressure switch register?

Janitrol Furnace issue motor would not start and pressure switch stuck closed [ 4 Answers ]

Hi I got this Janitrol Furnace it worked fine. Until my basement flooded then it looks like the circuit board got wet and it was on at the time. So basically I ordered a new board suppose to be coming soon. What happened was when the furnace came on like there were no flames only a bright...

View more questions Search