Ask Experts Questions for FREE Help !
Ask
    1964plymouth's Avatar
    1964plymouth Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 12, 2013, 05:10 PM
    Honeywell th8000 thermostat
    T stat is set to 70 and temp is 70 furnace comes on and temp is still 70 runs foe few min and turns off temp still 70 15 min later comes back on still 70
    Should it not drop 1 or 2 deg before it come on?
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Nov 13, 2013, 09:01 PM
    I believe there is an internal adjustment for that. Read over the set up instructions. There should also be a phone number for Honeywell in the manual. If you can't find the adjustment in the set up area of the manual, Honeywell can likely help you out.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell TH8000 Thermostat [ 0 Answers ]

My TH8000 thermostat controls a Unitary Products Group heat pump, and Nordhyne furnace. Everything is working fine,we think. BUT, why does the heat pump run when outside air temperatures are below zero degrees F? Should we be using a different System Setting on the TH8000 when outside air...

Honeywell TH8000 Thermostat [ 0 Answers ]

The TH8000 thermostat controls a Unitary Products Group heat pump, and Nordhyne furnace. Everything is working fine... we think. BUT, why does the heat pump run when outside air temperatures are below zero degrees F? Should we be using a different System Setting on the TH8000 when OAT falls below...

Honeywell TH8000 thermostat questions [ 5 Answers ]

After programming Heat set to 70 and Cool set to 78... When exactly do these functions kick in and turn off? And what median temp can you expect... 74?

Honeywell TH8000 thermostat [ 3 Answers ]

This thermostat was installed only 8 months ago and has worked fine until last night. It began a humming sound and the thermostate vibrates. What is causing this? The heater is working fine and all displays are normal. It is just this loud sound that is emitting from the thermostate itself and...

Honeywell TH8000 Thermostat [ 8 Answers ]

When this thermostat call for aux. heat, it reads aux. heat on the pad but no heat. The aux. heat works in manual mode. I think a setup code is wrong since it has never done right. Could someone help.

View more questions Search