Ask Experts Questions for FREE Help !
Ask
    pharandpierre's Avatar
    pharandpierre Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 11, 2013, 04:40 PM
    Intertherm furnace
    I have an Intertherm furnace model number MMHA-070AAHR-02. I quit working last night if I turn the power off and on again I tries to start but quits after half a minute without producing any heat. The red light on the sequencer flashes 3 times constantly. Could it be the ignition module?
    bstapish's Avatar
    bstapish Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Nov 22, 2013, 08:20 AM
    I have an intertherm it will ignite but blower won't come on. Email [email protected]
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #3

    Nov 23, 2013, 01:37 PM
    There should be a key to the blink code on the control panel door either inside or outside.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Intertherm Furnace Troubleshooting E2EB015HB furnace kicks on when suppose to and off [ 1 Answers ]

Furnace kicks on and off when suppose to but when blower shuts down the heating element doesn't have to flip switch to shut off element

Intertherm furnace codes? This furnace flashes the yellow light 6 times [ 0 Answers ]

Furnace will run for 30 seconds. It shuts down and the yellow light will flash 6 times and the does the same thing over and over. Red light stays steady. Thanks for the help.

Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks [ 3 Answers ]

I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.

Intertherm furnace [ 3 Answers ]

My 8 year old Intertherm forced air furnace won't fire. Igniter is good red led is blinking twice says it's a pressure switch is open. Anything I can do myself?

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

View more questions Search