Ask Experts Questions for FREE Help !
Ask
    belve66's Avatar
    belve66 Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 11, 2013, 08:53 AM
    Heil 867.768171 furnace will not ignite
    I have a Heil model 867.768171 natural gas furnace installed around 1990 that failed to heat last night. I opened the back panel and replaced a vacuum hose between the draft motor and the air pressure switch since it was dried out and had broken, using a rubber automotive hose that I had available. After powering down for a while, I turned the power switch on and the draft motor comes on immediately and runs indefinitely. I heard some faint clicks which stopped after several seconds. I never saw a glow from the ignitor or heard or smelled any gas. We are short staffed at work for the next several days and time off for a service call will be difficult right now. Any ideas on what I can do to get it going until I can have a professional look at it?

Check out some similar questions!

My Heil furnace NUGK075AG02 main burner will not ignite. Inducer motor runs, pilot [ 0 Answers ]

My Heil furnace NUGK075AG02 main burner will not ignite. Inducer motor runs, pilot lights, then a faint smell of gas and blower motor runs & runs

We have a heil super high efficiency furnace Model: NULK075DG05 / 867.779424 [ 1 Answers ]

We have a heil furnace Model: NULK075DG05 / 867.779424 and the red light is flashing on the control board. We have a manual but cannot find anything concerning the red light flashing and what it could mean. The furnace will start all the steps of igniting without actually igniting. We have checked...

Heil 7000 furnace, blower stays on and burners don't ignite [ 14 Answers ]

Furnace Info: -Upflow Condensing Gas Furnace is a Heil 7000 (model# NUGK075DG09) -Electric spark or host surface ignitor ( I think it's spark) -Installed Oct. '96 (when we built the house) -90% efficiency -wall thermostat is honeywell programmable. Don't know model but was also purchased in...

Heil unit won't ignite [ 8 Answers ]

What is the most likely cause of this inducer motor comes on but unit won't ignite model #pgaa36d1k3

Heil SP80 Won't Ignite [ 11 Answers ]

Last night when I went to bed the furnace was working fine. The power flickered on and off all night, and at 5 am I woke up freezing my butt off. It was 52 degrees in my house. I can hear it the furnace running, but it is not blowing any heat through the vents in my house, nor is it taking in...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.