Ask Experts Questions for FREE Help !
Ask
    builderman357's Avatar
    builderman357 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 3, 2013, 07:51 AM
    6.0 powerstroke power problems after computer upgrade
    Re-built motor and did a complete computer upgrade, now it has lost all get up and go from a dead stop. No pick up need help
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Nov 7, 2013, 02:03 PM
    My experience is that it's best to stick with the original chip and PCM. Your problem is all too common.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Powerstroke loss of power at full throttle? [ 1 Answers ]

97 f250 w/325k mi. runs fine until I throttle past 3/4 then totally loses power until rough idle for 1 or 2 min. at which time it smooths out and will run fine until throttling past about 3/4 again. Acts like fuel starvation. All new filters and oil. Have heard maybe fuel or injector pump or fuel...

Ford 7.3 L powerstroke loss of power [ 2 Answers ]

I have a 1994 ford powerstroke diesel 7.3 L. While accelerating the rmps will unexpectantly drop for a few seconds and then return to normal for a few minutes before doing it again. I have changed the fuel filter and cleaned the air filter. I am looking for any suggestions as to what may be causing...

2001 powerstroke 7.3 no power [ 3 Answers ]

I have a 2001 F-350 7.3 litre powerstroke with 200K on it. It seems to be down on power especially from 45 to 60 mph. When it is in overdrive at thse speeds you can't hear the turbo spooling at all. I have had the turbo replaced, the injectors checked twice once by my mechanic and once by the...

1997 F350 Powerstroke no power [ 2 Answers ]

I have a 1997 F350 Power stroke that has poor acceleration for the first 5-10 minutes until it warms up, does anyone have any suggestions for troubleshooting? Thanks Jim

View more questions Search