Ask Experts Questions for FREE Help !
Ask
    krip2454's Avatar
    krip2454 Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 2, 2013, 06:06 AM
    Mystery valve.
    I have a combination cylinder for my heating/hot water and there is a variable valve located at the bottom of it. What does it do and do I need to adjust it to gain maximum use out of my system?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Nov 2, 2013, 08:31 AM
    More details please! This valve, does it connect to a pipe or does it have a open end with a hose thread? Back to you, Tom
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
     
    #3

    Nov 3, 2013, 08:03 PM
    Take a photo of the valve and post it for us. Thank you. Milo

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Leaking hot water heater drain valve after new brass valve installed [ 2 Answers ]

I had a leaking (plastic) drain valve on my GE hot water heater. It was leaking from the inside of the valve. The small rubber washer was crimped. I installed a new brass drain valve that I purchased from home depot using teflon tape. The valve now leaks from the threads of the tank/valve. I...

Taco zone valve 571-2. Water flow not like the arrow in the valve's body. [ 0 Answers ]

I had a Taco zone valve 571-2 installed recently. Later I noticed that the valve is installed with the arrow in body of the valve pointing to the opposite direction of the actual water flow. I called the plumber and he said that this is not a problem and no damage will occur to the valve, the...

I have a early 90's Kohler shower valve and rounded out the cold stem valve seat. [ 2 Answers ]

Should I drill then retap the threads? Thanks!

I'd like to install a ball valve on main water line will a "Viperlok" valve work? [ 1 Answers ]

I know sweat soldering a ball valve is best, but will a "push-ft" compression "Viperlok" brand ball valve work?---My pipes are old copper, and have a few minor scratches and pits---I also noticed a seam running down one side of pipe. This water line runs out into garden, but valve is in the house....

Cold water pressure relief valve leaking, not the TRP valve [ 5 Answers ]

Hello. Cold water pressure relief valve start to drip water through the drain pipe. I replaced it with a new one but it is also dripping water. I have reduced water pressure in the house to the minimum by turning main water supply valve but it still leaking. Thanks for your help.


View more questions Search