Heil model#NUGK100DH08 GAS VALVE NOT OPENING

yug3 Posts: 1, Reputation: 1

New Member

Oct 29, 2013, 11:49 AM

Heil model#NUGK100DH08 GAS VALVE NOT OPENING

After replacing exhaust blower, I can not get the burner to light. Blower runs but no gas.

Grady White Posts: 1,417, Reputation: 59

Ultra Member

Oct 29, 2013, 06:49 PM

Did you get the hoses connected to the pressure switch correctly?

Add your answer here.

Check out some similar questions!

Furnace gas valve not opening [ 2 Answers ]

Regarding my Bryant/Payne 383KAV gas furnace: At startup both fans cycle as expected and the HSI gets red hot, but the gas valve does not open... no flame. It continues this cycle over and over. I have been unable to find any reset switches and have tried tapping on the gas valve solenoids. Any...

Gmp100-3 gas valve not opening [ 0 Answers ]

Furance stop working blower start, igniter glows gas valve doesn't open igniter goes off. Furnace stops running. I've tried connecting red and white wires from thermostat, replaced circuit board, and jumpered limit switches.the lead from pin #7 on circuit board reads 24v when ignitor glows.m...

Where can I find HEIL furnace model NUGK100DH08 wiring diagrams? [ 1 Answers ]

Where can I find HEIL furnace model NUGK100DH08 wiring diagrams?

Where can I find/buy a Heil gas furnace model NUGK100DH08 wiring diagram? [ 1 Answers ]

Where can I find/buy a Heil gas furnace model NUGK100DH08 wiring diagram?

Heil Gas Fur smart valve sv9541 cycles, clicks valve, lights pilot on off.Flame? [ 1 Answers ]

I have a Heil Natural Gas Furnace with smart valve sv9541 that goes off and the valve click as the ignitor glows on and off while lighting the pilot light which then goes out, and back lit?Is this a flame sensor problem? Thanks for advice.