Ask Experts Questions for FREE Help !
Ask
    timeye66's Avatar
    timeye66 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 24, 2013, 12:32 PM
    Lighting
    I have one switch for two lights and one switch for one light. Switches are on opposite ends of room. How can I wire this using one power supply of 12/2 wire?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Oct 24, 2013, 01:42 PM
    OK,
    Where is the power coming in at, one of the lights or one of the switches?
    Which lights are on which switch?
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Need light fixture for a obsoleted Progress Lighting 3 circuit track lighting system [ 1 Answers ]

I have an operating Progress Lighting 3 circuit tracking system that has one broken light fixture of its seven fixtures that are still operating.I need a replacement fixture since one is broken. Where can I try to get one? Thanks, Tom Madison

Pilot is lighting on home heater but no hot air and pilot is lighting but it continue [ 0 Answers ]

Here is my problem The hot air is not coming out from a/c ven Heat was working two days ago Pilot works but it starts then goes out or low then starts again but gas to burner doesn't start main burners for heater Tried circuit breaker and on/off switch and pilot screw adjust which did not...

Lighting [ 2 Answers ]

I apologize in advance for my lack of knowledge. In my basement I currently have a single 20A circuit with 6 lights on it, rated at 150W each, controlled by a single light switch. I'd like to know if its possible to break these lights up without adding circuits. Is it as simple as adding a...

Lighting Help [ 1 Answers ]

I currently have two hanging lights in my office, that both run off the same switch. I would like to change these to one small(3) track light, using the second light box (farthest from the switch). How do I remove the first one? Can I just cap off the wires? Will the switch still control the...

View more questions Search