[sandytsk]

The vehicle will start but not accelerate. Any ideas for the problem?

[sandytsk]

Are there any videos on troubles with 7.3 diesel engine?

[sandytsk]

I have a ford 7.3 powerstroke engine in my vehicle. It will start but I can't get it to accelerate. What should I do to fix it?

[TxGreaseMonkey]

. Purge fuel filter or fuel separator of water. Do this at least monthly--daily, if necessary. Water can be a big problem with diesels, particularly in the winter. Replace under hood and under frame fuel filters every 15,000 miles.

. Ensure engine oil is full and that the oil and filter have been recently changed. On Ford PSDs, I recommend only using Motorcraft oil and fuel filters. Alternative filters can adversely affect fuel pressure.

. Verify oil pressure on Ford PSDs with a known good mechanical gauge. Oil pressure may be too low. The cutoff will shut the engine down when the oil pressure is too low. PSDs use the Hydraulic Electronic Unit Injection (HEUI) System, so it completely relies on the oil level and condition of the oil to fire the injectors. Running the oil level low or too long can cause unusual problems.

As the name implies, the HEUI injection system uses hydraulic energy to actuate unit injectors. A PSD has two oil pumps--a low pressure lubrication pump, located near or in the front engine cover below the water pump, and a high pressure hydraulic pump, located at the front of the engine V, underneath the fuel filter assembly. If the problem persists, focus on the High Pressure Oil Pump. If the Injector Control Pressure (ICP) is lower than expected (engine cranking), it is usually caused by low injection oil pressure or regulator (IPR) valve. High pressure oil is used to pressurize and inject fuel into the cylinders--each injector is essentially its own injection pump. The IPR is a by-pass valve that controls the high oil pressure, depending on demand. The ICP Sensor monitors the oil pressure in the LH head. Check for oil in the upper reservoir--it should be within one inch of the top (add as necessary). Verify that the correct oil is being used and that it has not thinned out. For no-start concerns, check ICP Sensor readings with a scan tool or pressure gauge.

On diesel engines that will not restart, after they are warmed up, it's often a sign of a tired fuel pump. As they heat soak, inside pump head clearances increase and it will no longer develop sufficient fuel pressure at cranking speed. While it's running, fuel helps cool the pump by carrying the heat away.

. Check turbo--it may be coking up or turbine blades may be bent. Only use full-synthetic HDDO with a turbo. With conventional diesel engine oil, it's only a matter of time until the turbo fails.

. Check/replace air filter. Diesels require lots of air--restricted air filters can bend turbine blades. Check every 5,000 miles, replacing it as needed.

. Check for codes.