Ask Experts Questions for FREE Help !
Ask
    striha's Avatar
    striha Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 15, 2013, 12:10 PM
    Intertherm furnace
    Our intertherm furnace is collecting a large amount of water where the top fan is located. It is not at the bottom of the furnace but up by the top fan.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Oct 15, 2013, 08:14 PM
    Check the chimney cap. It could be missing or rusted thru.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Intertherm Furnace Troubleshooting E2EB015HB furnace kicks on when suppose to and off [ 1 Answers ]

Furnace kicks on and off when suppose to but when blower shuts down the heating element doesn't have to flip switch to shut off element

Intertherm furnace codes? This furnace flashes the yellow light 6 times [ 0 Answers ]

Furnace will run for 30 seconds. It shuts down and the yellow light will flash 6 times and the does the same thing over and over. Red light stays steady. Thanks for the help.

Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks [ 3 Answers ]

I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

View more questions Search