Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Electrical cables and connectors
[ 3 Answers ]
In using 2awg cables (copper). I have connectors rated for al/Cu. Will these end connectors increase the resistance? Or should I look for copper connectors?
Routing electrical cables
[ 12 Answers ]
1) can I run 1 12/3 romex cables through a 1/2" hole in studs. 2) can i run 2 12/2 romex cables in the same 3/4" hole in studs
Too many electrical cables
[ 3 Answers ]
I recently replaced the ceiling fan is my very old house. The original fan worked properly, had separate fan and light switches on the fixture, and was controlled by the light switch on the wall which also operated properly. When I dismantled the fan, I found two main electric cables coming from...
Electrical Cables
[ 1 Answers ]
Instead of using 2runs of 2Core 300Sqmm ( Legth - 1km ) cable for single phase load ( Phase & Neutral ) , can we use 1 run of 4 Core 300sqmm cable (Length -1 Km ) for the same load with 2core for Phase and 2 cores for neutral. View more questions Search
|