Ask Experts Questions for FREE Help !
Ask
    Jimmy Prophet's Avatar
    Jimmy Prophet Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 12, 2013, 09:21 AM
    WELL PUMP: Changed pump pipe size from 1/2" to 3/4" on a well pump
    I changed pump pipe size from 1/2" to 3/4" on a well pump. Now the system will not stop running. The piping was put back just like it was, except for the different size. No additional valves or anything different.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Oct 12, 2013, 10:04 AM
    Is the pump pumping water?
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #3

    Oct 14, 2013, 05:33 PM
    Did you prime the pump?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Looking for a 1990's dance/rap song with lyrics "Pump, Pump"... any clue? [ 2 Answers ]

Looking for a 1990's dance/rap song with lyrics "Pump, Pump"... any clue?

York heat pump and air handler, what is the low volt terminal "x" do? [ 0 Answers ]

I'm replacing a thermostat and of course there is an exra wire. In my old stat (honeywell chronotherm III) there is a terminal marked X. There is no information in the installation guide for new t stat(rth7400)for this terminal. It goes to the air handler and then to the heat pump where it is...

How do I get the "bottom" water pump retainging bolts off my 93 ford taurus? [ 2 Answers ]

I have a 1993 ford taurus 3.8L V6 automatic GL. I need to replace my water pump. I removed the drive belt and took off the four water pump pulley bolts. I am having trouble removing the "bottom" water pump-to-engine retaining bolts. I can't see the "bottom" bolts and can't get any type of wrench to...

Thermostat Wiring -- Where to put "O" wire if I have no heat pump [ 1 Answers ]

I'm trying to replace an old Dayton thermostat (Model 2E137) with a newer Honeywell (either the 6300B or the 7400). I have a Bryant 80 furnace in the basement and a Bryant Quantum Plus 550A air con outside. The Dayton thermostat has wires going to six terminals: R, 4, Y, W, G, and O I know...

Rheem heat pump thermostat "EM" setting [ 1 Answers ]

I have a Rheem model no. RHQA 1000B heat pump, but previous homeowner left no manual for it. I am puzzled at the "EM" setting on the thermostat. I would also like to download/obtain an operation manual for this unit.

View more questions Search