 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Cal Spa heat problem
Hello-drained and refilled tub now heat relay on 2004 CalSpa CS5000 will not close allowing no heat. Heat Element tested positive for resistance, pressure switch, temperature and high limit sensors are good. Pumps are working fine. Same situation several years ago but miraculously fixed itself after 4 days of cycling on and off. Happened again last year but it was a bad pressure switch.
Is it circuit board replacement time (: |
||||
Check out some similar questions!
Worked fine, no problems. Now all of a sudden not heating water at all. Is there a fuse or circuit breaker involved
Suddenly my tub is getting too hot and adjusting the thermostat won't shut down the heater and switching to the timer function worked for a day then that quit shuting down the heat. What's up?
I have a 1998 cal spa hot tub that won't heat up past 70 degrees. I took some advice on this site and have cleaned the filter and surrounding area and have checked for the heating element and for a switch- and found nothing (and I am not that savvy). To complicate matters, when I switched off the...
I just bought a 2004 Cal Spa 5000 used. We had it wired by an electrician, filled it up, released air from valves, and then turned it on. It made a humming noise and the jets turned on when we pressed the jets button. The temperature said 69 degrees. After less than a minute, the jets turned off...
I have a 1995 cal spa model PS-5-B the GFI tripped when the heat came on and the low speed motor I finally got the GFI to stay on when I turn up the thermostat to turn heat on the indicator light goes on but not the low speed side of pump. The high speed side of pump works fine on switch...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
