Ask Experts Questions for FREE Help !
Ask
    RRSMALLENGIN's Avatar
    RRSMALLENGIN Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Sep 27, 2013, 07:39 AM
    When performing and completing a static governor adjustment on a mechanical governor
    When performing and completing a static governor adjustment on a mechanical governor system, what is the relative position of the flyweights attached to the governor gear compared to the governor cup shaft? What is the relative position of the governor cup compared to the governor shaft?
    RRSMALLENGIN's Avatar
    RRSMALLENGIN Posts: 4, Reputation: 1
    New Member
    		  
    #2

    Sep 27, 2013, 07:43 AM
    When the flywheel magnets pass the trigger coil, energy is developed that causes the
    When the flywheel magnets pass the trigger coil, energy is developed that causes the Darlington transistor to open or close.
    RRSMALLENGIN's Avatar
    RRSMALLENGIN Posts: 4, Reputation: 1
    New Member
    		  
    #3

    Sep 27, 2013, 07:44 AM
    Which governor component applies force to the throttle shaft in an effort to move it
    Which governor component applies force to the throttle shaft in an effort to move it to the wide open throttle (WOT) position?
    RRSMALLENGIN's Avatar
    RRSMALLENGIN Posts: 4, Reputation: 1
    New Member
    		  
    #4

    Sep 27, 2013, 07:47 AM
    The "engine efficiency" of an air-cooled gasoline powered engine is less than 100% du
    The "engine efficiency" of an air-cooled gasoline powered engine is less than 100% due to inherent inefficiencies found in all engines. What is the efficiency conversion factor commonly used by Briggs & Stratton?
    N0help4u's Avatar
    N0help4u Posts: 19,823, Reputation: 2035
    Uber Member
    		  
    #5

    Sep 27, 2013, 07:49 AM
    True or false homework?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Governor adjustment on briggs & stratton [ 1 Answers ]

How do I adjust the governor on Briggs & Stratton riding mower model # 400707? A new fuel pump kit and tune-up has been done and engine runs smooth in high speed but lopes in low idle.

Briggs & Stratton Engine # 445777 0154-E1 - Governor Adjustment [ 0 Answers ]

I have Briggs & Stratton Engine # 445777 0154-E1, while running the tractor it began it throttled up high and would not slow down, shut it down - now I cannot find information on how to adjust the govenor or what needs to be replaced.

8hp tecumseh snowblower governor adjustment [ 7 Answers ]

Question 2010-1-11 about adj 8hp Tecumseh governor. Answer "to adj governor loosen pinch bolt and rotate governor shaft ccw." Does this mean to loosen the arm with the throttle linkage or the bolt that is below the bolt that is below the pinch bolt that clamps to the flat shaft on the governor? ...

Governor [ 1 Answers ]

Hi, well I am still working on the 16hp briggs engine.. got everything redone but can't get the cover on where the governor is attached.. is there a trick to getting it on, does the inside piece have to be in a certain position. When I slide the cover into place it lockes up the adjuster on top of...

View more questions Search