 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Immersion tank not filling
Had to turn hot water off because of a leak so opened up the hot taps and drained the tank , sortedf leak filled tank bk up but it will only fill half a bowl of water, then stops header tank is working and fine , un did the valve and water came out seeming to say the tank was full but when u run the hot tap the water only comes out enough to fill a washing up bowl half way then stops as to say no water left cold taps all fine
|
||||
Check out some similar questions!
I have a problem with cold water pressure on my street - if anyone else uses their cold water the pressure drops to almost nothing in my house. This is not too much of a problem for the cold water taps but it's extremely irritating when I am trying to have a shower on a morning. I have contacted...
Hello. I read previous questions regarding fluidmaster valve seal replacement #242. I bought this part because my toilet sometimes doesn't fill back up. However, the valve seal (new one) is different than my old one. The new seal has a nipple extension in the middle. My old seal is hollow in...
My immersion heater tank does not seem to be filling. Getting slow running hot water, tried to drain but only got a third of abucket
I have recently changed the thermostat in the immersion hot water tank. The water is heated twice a day through a timer. I have noticed that there is not hot water anymore. It starts fine, and then gets cool/cold after a short time. I can only find 1 heating element at the top of the tank. The...
Got a weird one. I have a toilet with (I think) a FluidMaster type float. Its got to be more than 10 years old. Anyway, yesterday it stopped filling the tank. If I twist the bottom slightly then the tank will fill, but after flushing it doesn't fill again. So its getting water through the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
