Ask Experts Questions for FREE Help !
Ask
    frhornsby's Avatar
    frhornsby Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 13, 2013, 09:27 PM
    Footing costs for Block Wall
    What is the estamated avg cost for a block wall footing 60ft long 3 ft ht in calif. Bay area
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Sep 14, 2013, 09:25 AM
    Not easy to "guess ". Suggest you get 3 estimates from reputable masonry contractors.
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
    		  
    #3

    Sep 14, 2013, 09:27 AM
    The best way, to get an estimate for the work you want done, would be to get 3 estimates from local contractors. Be sure that the same info is supplied to each.

    Chuck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Footing for a freestanding screen wall? [ 0 Answers ]

Hi - I want to build a freestanding privacy wall, about 64" tall and 16'long, to screen our hot tub from neighbor's view. I'll be using the retro "pierced" blocks that are one square foot and 4" thick. Will use 8"x8" blocks for piers at either end, and 8" x 8" x 16" blocks for center pier....

Bearing wall on edge of footing [ 12 Answers ]

Hi everyone, Planning a 2 story addition with full basement. One of the objectives is to have the first floor of the addition be a step or two lower that the first floor in the rest of the house. Beside just allowing for a higher ceiling in the new 1st floor room, the main reason is that the...

What is the recommended footing size for a 6' block wall with 4x8x16s? [ 0 Answers ]

I live in New river, AZ just north of phoenix. I'm building a Block wall including 4x8x16's and the ends etc will 8x8x16 A shaped blocks.. typical 6' block wall. What is the recommended footing size? Thanks

Rebar in block wall footing [ 9 Answers ]

I'm building a 3 foot block retaining wall, have a 2 foot wide, 2 foot deep footing dug. How many horizontal pieces of rebar should be in the footing and where should thet be placed?

Dialing in a footing to to build a wall to close in an existing attached garage [ 1 Answers ]

I'm in nc an inspector called me and told me to dial in a footing where I'm going to build a wall. I might drill about 8 two foot long rods into the existing 18' long footing then lay two #5 continuous rods tied to the rebars. Put some visqueen down. Here in oxford nc carolina they want the footing...

View more questions Search