Ask Experts Questions for FREE Help !
Ask
    V Lord58's Avatar
    V Lord58 Posts: 8, Reputation: 1
    New Member
     
    #1

    Aug 31, 2013, 06:13 AM
    Blocking up the chimney outlet
    Can somebody tell me why my neighbour (not approachable) would have the chimney pot taken from the roof and the hole covered with what appears to be a pillar top? I know my neighbour has had the old gas fire taken away and I assume a new fire (don't know what type) put in its place but is it dangerous to block up a chimney outlet. There isn't another property in my road that has had this done, can someone advise please?
    Vanessa
    tickle's Avatar
    tickle Posts: 23,796, Reputation: 2674
    Expert
     
    #2

    Aug 31, 2013, 06:40 AM
    If his heating source does not need a chimney, then I don't see the point in having one. You do have to leave a vent though, and have your outlet cleaned of soot and birds nests, etc. before covering it over. You are in the UK? If so, then do you know of any particular law that would forbid this?

    Why does this bother you; is it a danger to you in particular?
    joypulv's Avatar
    joypulv Posts: 21,591, Reputation: 2941
    current pert
     
    #3

    Aug 31, 2013, 07:31 AM
    Don't know what a 'pillar top' is but it might be vented out the sides. Maybe he put in electric heat. Maybe he put in a type that is vented out the side of the house, as many new ones can be, the same size as a dryer exhaust.
    V Lord58's Avatar
    V Lord58 Posts: 8, Reputation: 1
    New Member
     
    #4

    Sep 1, 2013, 08:36 AM
    I live in a semi detached bungalow and share an adjoining wall and chimney stack with my neighbour who does not speak to me since I reported him to the council ( not before warning him fist ) because he decided to extend his bungalow without permission and over my boundary. After nearly 20 years of being friendly they now don't speak to me and I was worried because two pots where taken down and only the one existing small metal outlet was left on the chimney top. That metal outlet has always been there but I was worried one of the pots removed was ours, I have a gas fire which needs a chimney. My neighbours home has always been an on-going project which I always just accepted until the boundary issue and I don't wish to cause any more bad feeling unnecessarily. A pillar top is a flat piece of brick ( like a small flagstone) which you put on the top of a brick pillar to finish off, I don't know whether they left any vents though. I was just worried this project was dangerous or would cause problems or damage to my home.
    Vanessa
    V Lord58's Avatar
    V Lord58 Posts: 8, Reputation: 1
    New Member
     
    #5

    Sep 1, 2013, 08:40 AM
    Thanks for that, A Pillar top is a flat piece of stone (like a small Flagstone) used on top of a stone pillar to finish off. I don't know whether they have left vents.
    Vanessa
    joypulv's Avatar
    joypulv Posts: 21,591, Reputation: 2941
    current pert
     
    #6

    Sep 1, 2013, 08:48 AM
    Oh sorry, I was wondering if you were being unduly nosy. Definitely follow up on this with the town building inspector. You could send some smoke up your chimney with a dye in it, I suppose, but I don't know what you would use. If you share the chimney, you can send a heating contractor up on the roof.
    It is always good to have your building plans on hand too.
    tickle's Avatar
    tickle Posts: 23,796, Reputation: 2674
    Expert
     
    #7

    Sep 1, 2013, 08:51 AM
    You are in the UK then, because you did mention 'the council'. If your semi detached is elderly, then yes, I would be worried as well, but if you are in the UK and this is an international site, I can only suggest you consult with a building inspector appointed by the council. I don't know if this would constitute a fire hazard or not.
    V Lord58's Avatar
    V Lord58 Posts: 8, Reputation: 1
    New Member
     
    #8

    Sep 1, 2013, 12:13 PM
    Thanks for your advice.
    Vanessa

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Plumbing directions for converting floor drain outlet toilet to back outlet [ 3 Answers ]

Former home remodeler, and fairly capable on general plumbing. How do I convert floor discharge outlet to back outlet for Briggs toilet?

Easier way to convert regular (assume 110v outlet) to 3 flat prong 125v/250v outlet? [ 3 Answers ]

I bought an electric clothes dryer thinking it would work with the regular outlets in apt. However, and no wonder the guy left in a hurry and got angry when I asked to return it, get money back, the end of the dryer plug is 3 flat prongs, with a sticker that says it is 125v/250v. Without rewiring...

If your chimney is in the center of your house, do you need a chimney liner to vent t [ 2 Answers ]

If your chimney is in the center of your house, do you need a chimney liner to vent the water heater?

Wall switch controlling a outlet,want to use outlet to control ceiling fan [ 3 Answers ]

I Have a wall swich that currently controls a baseboard outlet. The Wall switch has a white,black, ground coming in from the top of the box-- and a white,black,red,ground coming in from the bottom of the box. The two blacks are tied together/two whites tied together... the red goes to the switch...

Converting regular 3 prong electrical outlet to dryer outlet [ 3 Answers ]

We just bought a stacking washer and dryer and now the electrical cord on the dryer won't reach down to the existing dryer outlet. Is there any way to convert a regular 3 prong outlet that is close enough into a dryer outlet?


View more questions Search